You may notice that your fence is sagging or has gotten so dry that it is exposing your compound. The fence can break down completely without you noticing, if you are keen enough. The reason for the loss of fence integrity sometimes is a s a result of the details of the fence. If you are looking to replace your dilapidated fence, you should consider the following.
First, you need to be aware about the local zoning laws. There are certain structures which cannot be built without approval from the authorities. You should determine whether a permit is required before you commence the construction, even if you are doing it on the old space. You may end up getting fined for doing a construction without the permits and legal documents. The new fence needs to meet the set guidelines for it to stand. You may as well get fined or asked to put the fence down if it doesn’t comply with the set guidelines. You should also check with your utility provider even if you intend to build the fence on the same spot. This is important because you don’t want to interfere with water or electricity lines passing underground.
The materials to be used in the construction of the new fence ought to be looked at as well. You should bear in mind the number of years you want your new fence to last then identify the materials you are supposed to buy. You should also take into consideration the amount of money you have before you can go about to purchase the construction materials. If you want a fence that will last for longer, you must purchase materials of a higher quality. Obviously, you will spend more to get this type of wood, but if the money is enough, you can decide to replace the wood with the aluminum vinyl. In order for you to dig deeper for the posts, you need to eliminate all the materials belonging to the old fence from the site. A strong fence has to be constructed from the ground to the top with strong foundation and materials.
Finally, you need to map out the layout of your new fence. The position of the posts and the corner points must be identified as well. You can make those marks with the use of batters and strings. Digging of holes should then follow using a digging bar and shovel. Power augers can be used to dig the holes if the compound is huge because you may end up spending a lot of energy and time to accomplish the digging. You should ensure that the holes are deep enough according to the codes, and then set the posts in those holes.